Silicone SL-300 is an all-purpose stabilizer for manufacturing polyester polyurethane foams which does not contain any nonylphenol ethoxylates.
Physical properties | Appearance | Clear yellow liquid |
| Viscosity 25ºC | 50-200mPa.s |
| Density 25ºC | 0.95-1.01g/cm3 |
SL-300 alone is sufficient to achieve a uniform fine cell structure without additional dosage of cell regulators or emulsifiers.
Application SL-300 is a safe and reliable foam stabilizer which can be used in a wide range of formulations for polyester polyurethane foam.
SL-300 combines a well-balanced stabilizing effect with a high emulsifying efficiency.
SL-CLA in normal applied concentration can be safely used as another additive for improving the die-cuttability when SL-300 is applied as a stabilizer.
Instructions for use The recommended applied concentration of SL-300 can be varied between 0.8 parts and 1.5 parts per 100 parts polyester polyol depending on the used formulation.
The high level of the emulsifying characteristics of SL-300 ensures that clear and homo-geneous activator solutions are produced with the normally used applied concentratioin of any of customary ester foam catalysts,in particular with standard catalysts like e.g. Menhover amine AT-05 and amine AT-12.
Packaging 200 kg steel drum
1000 kg IBC
Instructions for storage For SL-300 we guarantee a shelf life of at least 12 months upon delivery under the condition,that it is stored in factory-packed containers and protected against extreme weather conditions,particularly against heat and moisture.
The solidification point of SL-300 is below -10ºC.At a temperature of approx -5ºC and below the clear liquid changes into a turbid dispersion.It is necessary to warm up under-cooled material to about ambient room temperature and stir it adequately while before use.
Information concerning Classification and labeling accordingly to regulations for transport of chemicals.
Protective measures for storage and handingling.
Measures in case of accidents and fires.
Toxicity and ecological effects in given in our material safety data sheet.
